Abstract
The present work deals with the transferability of Friction Riveting joining technology from laboratory equipment to adapted in-house, low-cost machinery. A G13 drilling machine was modified for the requirements of the selected joining technique, and joints were performed using polyethermide plates and AA2024 aluminum alloy rivets of 6 mm diameter. This diameter was not previously reported for Friction Riveting. The produced joints were mechanically tested under tensile loading (pullout tests) with ultimate tensile forces of 9500 ± 900 N. All tested specimens failed through full-rivet pullout, which is the weakest reported joint in Friction Riveting. In order to understand this behavior, FE models were created and analyzed. The models produced were in agreement with the experimental results, with failure initiated within the polymer under stress concentrations in the polymeric material above the deformed metallic anchor at an ultimate value of the stress of 878 MPa at the surface of the joint. Stresses decreased to less than half of the maximum value around the anchoring zone while the rivet was removed and towards the surface. The paper thus demonstrates the potential ease of applying and reproducing Friction Riveting with simple machinery, while contributing to an understanding of the mechanical behavior (initialization of failure) of joints.
DOI Link to Publication
