@misc{prashanth_processing_of_2016, 
author={Prashanth, K.G., Scudino, S., Chaubey, A.K., Loeber, L., Wang, P. Attar, H., Schimansky, F.P., Pyczak, P., Eckert, J.},
title={Processing of Al–12Si–TNM composites by selective laser melting and evaluation of compressive and wear properties},
year={2016},
howpublished = {journal article},
doi = {https://doi.org/10.1557/jmr.2015.326},
abstract = {Al–12Si (80 vol%)–Ti52.4Al42.2Nb4.4Mo0.9B0.06 (at.%) (TNM) composites were successfully produced by the selective laser melting (SLM). Detailed structural and microstructural analysis shows the formation of the Al6MoTi intermetallic phase due to the reaction of the TNM reinforcement with the Al–12Si matrix during SLM. Compression tests reveal that the composites exhibit significantly improved properties (∼140 and ∼160 MPa higher yield and ultimate compressive strengths, respectively) compared with the Al–12Si matrix. However, the samples break at ∼6% total strain under compression, thus showing a reduced plasticity of the composites. Sliding wear tests were carried out for both the Al–12Si matrix and the Al–12Si–TNM composites. The composites perform better under sliding wear conditions and the wear rate increases with increasing loads. At high loads, the wear takes place at three different rates and the wear rate decreases with increasing experiment duration.},
note = {Online available at: \url{https://doi.org/10.1557/jmr.2015.326} (DOI). Prashanth, K.; Scudino, S.; Chaubey, A.; Loeber, L.; Wang, P.; Schimansky, F.; Pyczak, P.; Eckert, J.: Processing of Al–12Si–TNM composites by selective laser melting and evaluation of compressive and wear properties. Journal of Materials Research. 2016. vol. 31, no. 1, 55-65. DOI: 10.1557/jmr.2015.326}}