@misc{fitseva_friction_surfacing_2015, 
author={Fitseva, V., Krohn, H., Hanke, S., dos Santos, J.F.},
title={Friction surfacing of Ti–6Al–4V: Process characteristics and deposition behaviour at various rotational speeds},
year={2015},
howpublished = {journal article},
doi = {https://doi.org/10.1016/j.surfcoat.2015.07.039},
abstract = {This investigation has shown that Ti–6Al–4V coatings can be effectively deposited onto a Ti–6Al–4V substrate by friction surfacing. A wide range of process parameters was established in which coatings of high quality have been obtained. The consumption rate control has been implemented as an efficient mode for the deposition of Ti–6Al–4V coatings. Temperature measurements at the coating interface have been accomplished showing that the coating material has been deformed in the β-phase. Furthermore, the homogeneity of the coating surface has been established to be a function of the rotational speed. The coatings exhibited a defect-free bond at the interface with the substrate. Two process parameter ranges with respect to the flash formation have been established. One of them enables flash-free coatings and the other generates coatings with flash formation on the retreating side, which can be controlled by the rotational and deposition speeds. Moreover, an increase in the rotational speed has been shown to lead to an increase in the coating thickness and width as well as an increase in the deposition efficiency up to 39 %.},
note = {Online available at: \url{https://doi.org/10.1016/j.surfcoat.2015.07.039} (DOI). Fitseva, V.; Krohn, H.; Hanke, S.; dos Santos, J.: Friction surfacing of Ti–6Al–4V: Process characteristics and deposition behaviour at various rotational speeds. Surface and Coatings Technology. 2015. vol. 278, 56-63. DOI: 10.1016/j.surfcoat.2015.07.039}}