@misc{esteves_friction_spot_2015, author={Esteves, J.V., Goushegir, S.M., dos Santos, J.F., Canto, L.B., Hage, E.Jr., Amancio-Filho, S.T.}, title={Friction spot joining of aluminum AA6181-T4 and carbon fiber-reinforced poly(phenylene sulfide): Effects of process parameters on the microstructure and mechanical strength}, year={2015}, howpublished = {journal article}, doi = {https://doi.org/10.1016/j.matdes.2014.06.070}, abstract = {Friction spot joining is an alternative technique to produce metal-composite overlap joints. The main process parameters are tool rotational speed, plunge depth, joining time and joining force. In this study, the individual effect of the process parameters on the microstructure and mechanical strength of hybrid AA6181-T4/CF-PPS double lap joints was investigated using Taguchi method and analysis of variance (ANOVA). Produced joints presented mechanical performance from 2107 N to 3523 N. Joints failed by brittle fracture at the interface between aluminum alloy and composite, with displacement-at-peak load values from 0.7 mm to 0.9 mm. Tool rotational speed was the parameter with the largest influence on the joint shear resistance, followed by the joining time, plunge depth and joining force. Higher strength was correlated to the extension of the bonding area and macro-mechanical interlocking related to the formation of a metallic indentation (metallic nub) slightly inserted into the composite. Larger bonding areas were shown to be related to higher heat input (as a result of longer joining times and intermediate rotational speeds) leading to larger consolidated polymeric layers at the metal-composite interface. Higher macro-mechanical interlocking was obtained at larger plunge depths. Joining force was shown to be related to crevice and pore filling of the metal surface by supporting spreading of the molten polymer. Higher joining forces led to better wetting of the interface, increasing adhesive forces and joint mechanical performance. Nevertheless excessive joining forces caused squeezing flow of the molten layer reducing joint strength, since a large adhesive area was lost.}, note = {Online available at: \url{https://doi.org/10.1016/j.matdes.2014.06.070} (DOI). Esteves, J.; Goushegir, S.; dos Santos, J.; Canto, L.; Hage, E.; Amancio-Filho, S.: Friction spot joining of aluminum AA6181-T4 and carbon fiber-reinforced poly(phenylene sulfide): Effects of process parameters on the microstructure and mechanical strength. Materials and Design. 2015. vol. 66 B, 437-445. DOI: 10.1016/j.matdes.2014.06.070}}