%0 journal article %@ 0043-1648 %A Hanke, S., Beyer, M., Silvonen, A., dos Santos, J.F., Fischer, A. %D 2013 %J Wear %N 1-2 %P 415-423 %R doi:10.1016/j.wear.2012.11.016 %T Cavitation erosion of Cr60Ni40 coatings generated by friction surfacing %U https://doi.org/10.1016/j.wear.2012.11.016 1-2 %X CrNi-alloys with high Cr-content generally are quite brittle and, therefore, only available as castings and regarded as neither weldable nor deformable. The process of friction surfacing offers a possibility to generate Cr60Ni40 coatings e.g. on steel or Ni-base substrates. Cavitation tests were carried out using an ultrasonic vibratory test rig (∼ASTM G32) with cast specimens and friction surfaced coatings. The coatings show less deformation and smaller disruptions, and wear rates in steady state were found to be three times higher for the cast and heat treated samples than for the coatings, caused by a highly wear resistant Cr-rich phase. The results of this study show that it is possible to generate defect free coatings of Cr60Ni40 with a thickness of about 250 μm by friction surfacing, which under cavitation show a better wear behavior than the cast material. Thus, in combination with a ductile substrate, these coatings are likely to extend the range of applicability of such high-temperature corrosion resistant alloys.