%0 journal article
%@ 2213-9567
%A Woo, S.K.,Pei, R.,Al-Samman, T.,Letzig, D.,Yi, S.

%D 2023
%J Journal of Magnesium and Alloys
%N 2
%P 543-552 
%R doi:10.1016/j.jma.2022.12.004
%T Effects of Ca and Nd addition on plastic instability in extruded Mg-Mn alloy deformed under various conditions
%U https://doi.org/10.1016/j.jma.2022.12.004
2 
%X Plastic instability, called Portevin-Le-Chatelier (PLC) effect, manifests itself as an unstable plastic flow during tensile tests of structural materials. This phenomenon has a strong influence on diverse properties, leading to unexpected vulnerabilities in the service environment. Among various magnesium-based alloys, PLC phenomenon is most prominently observed in the Mg-Mn-Nd alloy under elevated temperature and low strain rate conditions. An important aim of the study is to clarify and compare the significance of the RE and Ca addition, which are known to cause a formation of a largely weakened non-basal type texture, in the occurrence of plastic instability. Due to the PLC phenomenon, there is a risk of weakening texture and formability improvement by the addition of RE and Ca elements in Mg alloys. Based on the understanding of the role of Nd to the PLC phenomenon in Mg-Mn alloy identified in previous studies, the PLC characteristics according to alloying elements and deformation conditions were compared and analyzed. To identify the micromechanical mechanisms of the PLC phenomenon, varies in the microstructure and mechanical properties during deformation of Mg-Mn binary and Ca or Nd-containing Mg-Mn-based ternary alloys in various conditions were systemically analyzed. The addition of Ca did not show a marked PLC effect due to the formation of low number density Mn-Ca and Ca-Ca solute clusters and an unbalanced Mn:Ca ratio. In contrast, the addition of Nd leads to the formation of a higher number density of Nd-Nd and Mn-Nd solute clusters than that of Ca-Ca and Mn-Ca solute clusters of the Mg-Mn-Ca alloy, resulting in a stable solute-dislocation interaction atmosphere under specific ranges of deformation temperature and strain rate. The deformation in the regime of PLC phenomenon, results in a decrease in ductility and an increase in strength, despite deformation at elevated temperatures with maintaining the weakened texture.