%0 journal article
%@ 2352-4928
%A Maheswari, N.,Amirthalingam, M.,Schwedt, A.,Brokmeier, H.G.,Schell, N.,Mayer, J.,Kumar, K.C.H.,Sankaran, S.

%D 2021
%J Materials Today : Communications
%N 
%P 102918 
%R doi:10.1016/j.mtcomm.2021.102918
%T Temperature dependent partitioning mechanisms and its associated microstructural evolution in a CMnSiAl quenching and partitioning (Q&P) steel
%U https://doi.org/10.1016/j.mtcomm.2021.102918
 
%X The effect of temperature (350 °C ¡ M ¡ 450 °C) on the partitioning mechanisms and the final microstructure evolution in a CMnSiAl quenching and partitioning (Q&P) steel was investigated. The microstructure of both the Q&P specimens, comprised of distorted BCC or pseudo tetragonal martensite structure with two different characteristics namely (i) tempered or carbon depleted martensite that formed during initial quenching (M ¡ 240 °C ¡ M) and partitioning step and (ii) carbon enriched fresh martensite that formed after partitioning step and final quenching (RT) together with blocky and inter-lath films of retained austenite. In addition, packets of M/A constituents were observed in Q&P-350-1min specimen and some traces of carbide and plate martensite were observed in Q&P-450-1min specimen. The increase in partitioning temperature led to nearly 2% increase in the amount of retained austenite (both blocky and inter-lath) with increased carbon content of 0.27 wt.%. Along with carbon partitioning, slight interface mobility/isothermal martensite formation was also observed in the case of specimen partitioned at 350 °C, whereas tempering effect was predominantly seen in the case of specimen partitioned at 450 °C. Irrespective of the partitioning temperature, the amount of carbon required to stabilize the retained austenite at RT was found to be about 1.15 wt.% and was confirmed through APT analysis.