%0 journal article
%@ 0010-938X
%A Liang, J.,Srinivasan, P.B.,Blawert, C.,Dietzel, W.

%D 2010
%J Corrosion Science
%N 2
%P 540-547 
%R doi:10.1016/j.corsci.2009.10.011
%T Influence of pH on the deterioration of plasma electrolytic oxidation coated AM50 magnesium alloy in NaCl solutions
%U https://doi.org/10.1016/j.corsci.2009.10.011
2 
%X The corrosion deterioration process of plasma electrolytic oxidation (PEO) coatings on AM50 magnesium alloy prepared from two different based electrolytes, i.e., an alkaline phosphate electrolyte and an acidic fluozirconate electrolyte, were investigated using electrochemical impedance spectroscopy (EIS) in a 0.1 M NaCl solution with pH of 3, 7 and 11, respectively. It was found that the PEO coating formed in alkaline phosphate electrolyte, which was composed mainly of MgO, suffered from rapid chemical dissolution and lost its protection capability very quickly in acidic NaCl solution (pH 3). The chemical dissolution of this PEO coating was retarded in neutral NaCl solution (pH 7) and the corrosion damage was localized in this environment. On the other hand, in the alkaline NaCl solution (pH 11), the MgO coating underwent only slight degradation. The PEO coating produced in acidic fluozirconate electrolyte, the failure was marked by the flaking-off of the large areas of coating in acidic NaCl solution (pH 3). However, in the neutral and alkaline NaCl solutions, the coating underwent only a slight degradation without any observable corrosion damage in the 50 h test. The results showed that the deterioration process of PEO coated magnesium alloy was governed mostly by the pH of NaCl solution and it was also strongly related to the microstructure and composition of the PEO coatings.