%0 journal article
%@ 0257-8972
%A Gaertner, F.,Stoltenhoff, T.,Voyer, J.,Riekehr, S.,Kocak, M.

%D 2006
%J Surface and Coatings Technology
%N 24
%P 6770-6782 
%R doi:10.1016/j.surfcoat.2005.10.007
%T Mechanical properties of cold-sprayed and thermally sprayed copper coatings
%U https://doi.org/10.1016/j.surfcoat.2005.10.007
24 
%X The present investigation compares the mechanical properties of cold-sprayed and thermally sprayed copper coatings. The mechanical,properties of the Cu-coatings are determined by in plane tensile test using micro-flat tensile specimen technique. A deeper view into the type of obtained defects, their stability and their influence on coating performance, is supplied by subsequent failure analyses and the comparison to annealed copper coatings. The results demonstrate that cold-sprayed coatings, processed with helium as propellant gas, show similar performance as highly deformed bulk copper sheets and respective changes in properties after annealing. In the as-sprayed condition, cold-sprayed coatings,processed with nitrogen and thermally sprayed coatings show rather brittle behavior. Whereas subsequent annealing can improve the properties of the cold-sprayed coating, processed with nitrogen, such heat treatments have only minor influence on the tensile properties of thermally sprayed,copper coatings. The investigation of failure modes for the as-sprayed states and after different heat treatments provided further information concerning particle–particle bonding and the effect of oxides on mechanical properties.